|Version 1 (modified by khali, 5 years ago)|
Contributed by Matt Roberds.
# Second cut at a minimal sensors3.conf for Asus M2N-SLI Deluxe motherboard # Based on existing entries in sensors3.conf and Jean Delvare's configuration # for the Asus M2N32-SLI # Matt Roberds, 21 Feb 2008 chip "it8716-*" # Voltages label in0 "VCore" label in1 "VDDR" # Not in BIOS ignore in2 # 3.3 V is monitored by adt7475 label in3 "+5V" # VCC label in4 "+12V" ignore in5 # -12 V not monitored ignore in6 # -5 V not monitored label in7 "5VSB" # Not in BIOS label in8 "VBat" # Not in BIOS # Vcore, VDDR, and Vbat are connected directly, so no compute # line is needed for these. For +5V, +12V and 5VSB, the default # resistors seem to have been used. compute in3 ((6.8/10)+1)*@ , @/((6.8/10)+1) compute in4 ((30/10)+1)*@ , @/((30/10)+1) compute in7 ((6.8/10)+1)*@ , @/((6.8/10)+1) # Temperatures # Not sure. temp1 always reads close to what k8temp reports for Core0, # and to what the BIOS reports as the CPU temperature. temp2 is between # temp1 and temp3; it is close to what the BIOS reports as the motherboard # temperature. temp3 always reads approximate ambient temperature. label temp1 "CPU Temp" label temp2 "MB Temp" label temp3 "MB Temp" # Fans label fan1 "CPU Fan" label fan2 "Chassis Fan 1" label fan3 "Power Supply Fan" # Ignore fans you don't have # ignore fan2 # ignore fan3 chip "adt7475-*" # Note: this section depends on some further hacks I have made to # Jordan Crouse's driver # Voltages ignore in1 label in2 "+3.3V" # Temperatures # temp1 and temp3 don't appear to be hooked up; temp2 is on board the # adt7475 chip itself. ignore temp1 label temp2 "ADT7475 Temp" ignore temp3 # Fans label fan1 "Chassis Fan 4" label fan2 "Chassis Fan 2" label fan3 "Chassis Fan 3" ignore fan4 # Ignore fans you don't have # ignore fan1 # ignore fan2 # ignore fan3 chip "k8temp-*" label temp1 "core0 temp" label temp3 "core1 temp"