Ticket #93 (closed task)
Opened 7 years ago
Only one temp for dual CPU system. (Examined/Solved - lm_sensors 2.4.5, linux 2.2.14)
|Reported by:||contact||Owned by:||somebody|
I have an epox KP6-BS, with two celerons installed. lm_sensors compiled and loads fine. Values in /proc/sys/dev/lm78-j-i2c-1-2d and /lm78-j-isa-0290 are about what the bios reports. However, there's only one temp entry there. I set SMP=1 in the makefile for lm_sensors and i2c, but that didn't seem to change anything. Thanks, Adam. --- It depends on your hardware whether you can get any more information. The LM78 just has one temperature input (and setting SMP to 1 won't change that :-)), and it is probably measuring the mainboard temperature and nothing else. It may be you have LM75 chips too; run sensors-detect to determine this. If so, they may be connected to your processors; then again, they may not. It all depends on your mainboard manufacturer. By the way, those two detected LM78 chips are one and the same that is connected to two interfaces, both an ISA and a I2C one.